ProComp LA Gold 1800 Zetec

Up and running with an ME product? Tell the world here!
Jackracing
Apprentice
Posts: 4
Joined: Fri Jul 10, 2015 2:34 pm

ProComp LA Gold 1800 Zetec

Postby Jackracing » Fri Aug 14, 2015 12:13 pm

I could well be the first ProComp LA Gold owner to go down this route

Zetec NoDiz ordered yesterday at 13:30.

Arrived today at 11:30

Speedy

Jackracing
Apprentice
Posts: 4
Joined: Fri Jul 10, 2015 2:34 pm

Re: ProComp LA Gold 1800 Zetec

Postby Jackracing » Fri Aug 14, 2015 4:58 pm

Well, unless I am missing something, this piece of kit does exactly what it says on the tin. :mrgreen:

In fairness, I purchased the already wired, based mapped Zetec option.
I get on with wiring like Herod got on with child care. :?

I have yet to take the car for a run. :?:

User avatar
Matt@ME
Guru
Posts: 534
Joined: Thu Feb 13, 2014 10:12 am

Re: ProComp LA Gold 1800 Zetec

Postby Matt@ME » Mon Aug 17, 2015 10:14 am

Jackracing,

Great to hear, look forward for 'on-track' feedback.

Regards
Matt
Hardware Engineer, Motorsports Electronics Limited

Jackracing
Apprentice
Posts: 4
Joined: Fri Jul 10, 2015 2:34 pm

Re: ProComp LA Gold 1800 Zetec

Postby Jackracing » Thu Oct 15, 2015 8:58 am

It has taken a while, but at last some track time.

The MGCC Heritage 4 Hour Race at Snetterton.

I had previously trial fitted the Nodiz but not road tested or been on the rollers.
The fit for the race was not exactly the best. Wrapped in garage blue roll and gaffer taped to the bulkhead.

3 cars and drivers, 4 hours of racing. Nodiz was going to be tested.
It got tested harder than planned, we lost a car in the first 4 minutes.

That left me with an untried Nodiz and Ian in a Fisher fury with both a new Nodiz and a VVT controller.

It is safe to say that the kit performed well and does what it says on the tin.
It works strait out of the box.

Matt,
at some point over the winter I will visit for a session on the rollers and do some fine tuning.

Regards
Jack


Return to “Success Stories”

Who is online

Users browsing this forum: No registered users and 1 guest