DanST bike bodie...best map sensor take off solution?

Support, tips, maps - anything relating to the new MX-5 PnP!
mark2018
Apprentice
Posts: 1
Joined: Fri Dec 14, 2018 9:35 am

DanST bike bodie...best map sensor take off solution?

Postby mark2018 » Fri Dec 14, 2018 9:41 am

When fitting DanST or similar bike throttle bodies, any suggestions for the best map sensor pipe pick up solution? Just off one runner enough or ideally off all four..if so, how did you do it??

Cheers!¬

dickiersltd
Apprentice
Posts: 11
Joined: Sat Jun 27, 2015 1:40 pm

Re: DanST bike bodie...best map sensor take off solution?

Postby dickiersltd » Sun Feb 17, 2019 10:08 pm

Hi,
I bought a 6 way vacuum block from the bay and plumbed it into all four runners on my Danst GSXR 750 set up.
I have also plumbed in the Idle control valve to the block. ( this needs some tweeking on my car )
I just need to open the throttle a tiny bit to start and have tickover at 1100 RPM.
I have also plumbed the vacuum for the brake servo into it.

Cheers Dickie

sunny2019
Apprentice
Posts: 6
Joined: Fri Mar 15, 2019 9:56 am

Re: DanST bike bodie...best map sensor take off solution?

Postby sunny2019 » Fri Mar 15, 2019 9:59 am

Oh! This article has suggested to me many new ideas. I will embark on doing it. Hope you can continue to contribute your talents in this area. Thank you.
wuxiaworld


Return to “ME221 Miata/MX5 Plug-n-Play”

Who is online

Users browsing this forum: No registered users and 1 guest